| Weight | 1.4 kg |
|---|---|
| Dimensions | 9 × 20.5 × 13 cm |
Hot
Victron Energy SmartSolar 100/50 MPPT solar charge controller
$494.18
Victron Energy 50A MPPT Solar Charge Controller
A solar charger gathers energy from your solar panels, and stores it in your batteries. Using the latest, fastest technology, SmartSolar maximizes this energy-harvest, driving it intelligently to achieve full charge in the shortest possible time. SmartSolar maintains battery health, extending its life.
By constantly monitoring the voltage and current output of your solar (PV) panels, MPPT technology ensures that every drop of available power is rinsed out of your panels, and harvested for storage. The advantage of this is most noticeable when the sky is partially clouded, and light intensity is constantly changing.
Remotely control and monitor the extensive features of your SmartSolar MPPT charger with built-in bluetooth by pairing it with your smartphone or other device via VictronConnect. If your installation is connected to the internet Victron Remote Management Portal (VRM) provides access to the full power of your MPPT, anytime, anywhere; both services are free to use. For remote installations – even when there is no internet connection or phone signal nearby – you may be able to monitor your MPPT by bluetooth-pairing with a LoRaWAN (long-range wide area network) device, available optionally.
Features and Specifications:
- Bluetooth Smart built-in: dongle not needed
- VE.Direct data connection
- Ultra-fast Maximum Power Point Tracking (MPPT)
- Advanced Maximum Power Point Detection in case of partial shading conditions
- Outstanding conversion efficiency
- Flexible charge algorithm
- Extensive electronic protection
- Internal temperature sensor
- Real-time data display options
- Rated charge current: 50 Amps
- Max. PV short circuit current: 60 Amps
- Maximum PV open circuit voltage: 100 Volts
- Maximum wire size: #6 AWG
- Weight: 2.87 lbs (1.3 kg)
- Dimensions (inches / millimeters): 5.12″ x 7.32″ x 2.76″ / 130 x 186 x 70 mm
- 5 year warranty
Additional information
Related products
Close
TriStar 60 amp Controller
MorningStar TriStar Controller is a three function controller that provides reliable solar battery charging, load control or diversion regulation. The controller operates in one of these modes at a time and two or more controllers may be used to provide multiple functions.
Available in 45 or 60 amps at 12-48 volts, and has an optional meter, remote meter and remote temperature sensor.
Photo shown has the optional display meter installed on front of unit.
Five year warranty. Contact MornigStar for complete terms.
Hot
Close
Victron Energy SmartSolar MPPT 150/100-Tr Solar Charge Controller
SmartSolar charge controller
The Victron Energy SmartSolar MPPT 150/100-Tr Solar Charge Controller gathers energy from your solar panels, and stores it in your batteries. Using the latest, fastest technology, SmartSolar maximizes this energy-harvest, driving it intelligently to achieve full charge in the shortest possible time. SmartSolar maintains battery health, extending its life.
By constantly monitoring the voltage and current output of your solar (PV) panels, MPPT technology ensures that every drop of available power is rinsed out of your panels, and harvested for storage. The advantage of this is most noticeable when the sky is partially clouded, and light intensity is constantly changing.
Remotely control and monitor the extensive features of your SmartSolar MPPT charger with built-in Bluetooth by pairing it with your smartphone or other device via VictronConnect. If your installation is connected to the internet Victron Remote Management Portal (VRM) provides access to the full power of your MPPT, anytime, anywhere; both services are free to use. For remote installations – even when there is no internet connection or phone signal nearby – you may be able to monitor your MPPT by Bluetooth-pairing with a LoRaWAN (long-range wide area network) device, available optionally.
By adding the SmartSolar Control Display you will be able to check the status of your Charger and battery-storage at a glance. Simply plug it into the face of your MPPT charger to provide you with real-time monitoring and set-up capabilities.
Features and Specifications:
– Ultra-fast Maximum Power Point Tracking (MPPT)
– Advanced Maximum Power Point Detection in case of partial shading conditions
– Outstanding conversion efficiency
– Flexible charge algorithm
– Internal temperature sensor
– Bluetooth Smart built-in: dongle not needed
– Programmable relay
– Optional: pluggable LCD display
– 5 year warranty
Hot
Close
Victron Energy MultiPlus 12/3000/120-50 120V VE.Bus
Multi-functional
The Victron Energy MultiPlus 12/3000/120-50 120V VE.Bus is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology and a high-speed AC transfer switch in a single compact enclosure. Models range from 800VA to 5000VA per module.
Unique PowerAssist feature
The MultiPlus will prevent overload of a limited AC source. First, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or shore side supply with power taken from the battery.
Uninterrupted AC power (UPS function)
In the event of a grid failure or shore or generator power being disconnected, the inverter within the Multi is automatically activated and takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption.
Virtually unlimited power thanks to parallel operation
Up to 6 Multis can operate in parallel to achieve higher power output. Three phase or split phase operation is also possible. Please check our datasheets to see which models have paralleling, three phase and split phase capabilities.
Close
Midnite Classic 150MPPT
The Classic MPPT Charge Controller substantially increases the flexibility, features and range currently found on MPPT controllers. The Classic is the first MPPT controller that has Arc Fault Protection, making this controller the safest available today.
FEATURES:
- 150 operating voltage
- Max current out: 96 amps
- 12-72V battery charging standard with models up to 120V battery bank
- Built in DC-GFP and Arc Fault Detector
- Solar, wind and hydro MPPT modes
- Set up Wizard
- 32 megs of data logging
Listed by ETL for US & Canada
CE Certified Listed
Victron Energy MultiPlus 24/3000/70-50 120V VE.Bus
Multi-functional
The Victron Energy MultiPlus 24/3000/70-50 120V VE.Bus is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology and a high-speed AC transfer switch in a single compact enclosure. Models range from 800VA to 5000VA per module.
Unique PowerAssist feature
The MultiPlus will prevent overload of a limited AC source. First, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or shore side supply with power taken from the battery.
Uninterrupted AC power (UPS function)
In the event of a grid failure or shore or generator power being disconnected, the inverter within the Multi is automatically activated and takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption.
Virtually unlimited power thanks to parallel operation
Up to 6 Multis can operate in parallel to achieve higher power output. Three phase or split phase operation is also possible. Please check our datasheets to see which models have paralleling, three phase and split phase capabilities.
SaleHot
Close
Outback FM 80 Mppt Controller
Outback FM80 MPPT Charge Controllers
FLEXmax MPPT Charge Controllers are a great solar charge controller when you require a high performance, efficient and versatile charge controller for your advanced power system.
Features & Attributes
- Easy to use and understand LCD display
- Rated to 80 A DC output current
- Fully adjustable control set points
- Allows use with virtually any battery type
- An optional Mate can be added to allow monitoring and control from up to 300 feet away
- Dimensions (LxWxH): 16.3 × 5.6 × 4 inches
- Weight: 14 lbs
- Five year warranty
Hot
Close
Victron Energy Color Control GX
The Color Control GX (CCGX) provides intuitive control and monitoring for all products connected to it. The list of Victron products that can be connected is endless: Inverters, Multis, Quattros, MPPT 150/70, BMV-700 series, Skylla-i, Lynx Ion and even more.
Victron Energy system monitoring
The Color Control GX is the communication-centre of your installation. It offers at-a-glance live information, and lets you control all products connected to it. Full system control is gained – almost anywhere in the world – by accessing your Color Control GX using free-to-use Victron Remote Management Portal (VRM).
Close
Sun Charger 30
Blue Sky Energy’s new Sun Charger 30 solar charge controller charges 12 volt batteries at up to 30 amps.
The Sun Charger 30 uses precise PWM charge voltage control combined with a sophisticated 3-stage charge algorithm to optimally charge flooded, GEL or AGM lead-acid chemistry batteries. To periodically condition flooded batteries the Sun Charger 30 will also perform a manual or automatic Equalization charge.
The built in low power LED digital display combines excellent readability with very low power consumption, includes an automatic night time diming feature and may be turned off completely if desired. The high accuracy display shows battery voltage, solar charge current, and computes total solar charge amp-hours produced.
To provide optimal charge control for various battery types all charge settings are user adjustable. The automatic or manual Equalization and solar charge amp-hour counter features are unique to the Sun Charger 30.
The Solar Boost Sun Charger 30 includes a 5 year warranty.